This time we will construct the building using the wall tool instead of extruded 2D primitives!
Again make a new Layer (Walls).
With the 3D Model Layer showing with Snapping Enabled start to draw the straight wall sections (first set the wall thickness to 200mm)
Next draw the curved section of the wall using the Wall by Radius Mode. We can use the center point of the circle in a layer below as a start point.
Set the z Heights for the walls.
You may need to join any walls that are Un-joined.
Again make a new Layer (Walls).
With the 3D Model Layer showing with Snapping Enabled start to draw the straight wall sections (first set the wall thickness to 200mm)
Next draw the curved section of the wall using the Wall by Radius Mode. We can use the center point of the circle in a layer below as a start point.
Set the z Heights for the walls.
You may need to join any walls that are Un-joined.
No comments:
Post a Comment